Initializing help system before first use

MIPRAMPUP

Description
Controls the strategy used by the parallel MIP solver during the ramp-up phase of a branch-and-bound tree search.
Type
Integer
Values
-1 
Automatically determined.
0 
No special treatment during the ramp-up phase. Always run with the maximal number of tasks.
1 
Limit the number of tasks until the initial dives have completed.
Default value
-1
Note
The branch-and-bound tree search starts from the single root node, and only through branching on this root node and the resulting child nodes, are enough active nodes created to produce sufficient tasks to keep all MIP workers busy. This is referred to as the ramp-up phase of a parallel MIP. In a typical MIP solve, the solutions found during the initial dives will typically provide a significant improvement over the root heuristic solutions. It can therefore be advantageous to let these initial dives run as fast as possible, by limiting resource contention. This can be accomplished by restricting the number of parallel tasks and thereby reducing the memory bus contention. The MIPRAMPUP control can be used to turn this initial task restriction of a parallel MIP solve on or off.
Affects routines
XPRSmipoptimize ( MIPOPTIMIZE).
See also
MIPTHREADS, MAXMIPTASKS.

Parent Topic Control Parameters

© 2001-2020 Fair Isaac Corporation. All rights reserved. This documentation is the property of Fair Isaac Corporation (“FICO”). Receipt or possession of this documentation does not convey rights to disclose, reproduce, make derivative works, use, or allow others to use it except solely for internal evaluation purposes to determine whether to purchase a license to the software described in this documentation, or as otherwise set forth in a written software license agreement between you and FICO (or a FICO affiliate). Use of this documentation and the software described in it must conform strictly to the foregoing permitted uses, and no other use is permitted.