Initializing help system before first use

MAXTIME

Description
This parameter is deprecated and will be removed in a future release.
The maximum time in seconds that the Optimizer will run before it terminates, including the problem setup time and solution time. For MIP problems, this is the total time taken to solve all nodes.
Type
Integer
Values
0 
No time limit.
n>0 
If an integer solution has been found, stop MIP search after n seconds, otherwise continue until an integer solution is finally found.
n<0 
Stop in LP or MIP search after n seconds.
Default value
0
Note
This control has been deprecated with Xpress Optimizer version 9.0; the double control TIMELIMIT should be used instead. Note that the meaning of positive values differs between TIMELIMIT and MAXTIME. The functionality of positive MAXTIME values is covered by SOLTIMELIMIT. When both controls are set, the new TIMELIMIT control will take precedence.
Affects routines
XPRSlpoptimize ( LPOPTIMIZE), XPRSmipoptimize ( MIPOPTIMIZE).
See also
TIMELIMIT, SOLTIMELIMIT.

Parent Topic Control Parameters

© 2001-2024 Fair Isaac Corporation. All rights reserved. This documentation is the property of Fair Isaac Corporation (“FICO”). Receipt or possession of this documentation does not convey rights to disclose, reproduce, make derivative works, use, or allow others to use it except solely for internal evaluation purposes to determine whether to purchase a license to the software described in this documentation, or as otherwise set forth in a written software license agreement between you and FICO (or a FICO affiliate). Use of this documentation and the software described in it must conform strictly to the foregoing permitted uses, and no other use is permitted.