CHECKSONMAXTIME
|
Description
|
This attribute is used to set the value of the
MAXCHECKSONMAXTIME control. Its value is the number of times the optimizer checked the
MAXTIME criterion during the last call to the optimization routine
XPRSmipoptimize. If a run terminates on the
MAXTIME criterion then the attribute is the negative of the number of times the optimizer checked the
MAXTIME criterion up to and including the check when the termination was activated. Note that the attribute is set to zero at the beginning of each call to an optimization routine.
|
|
Type
|
Integer
|
|
Topic area
|
|
|
Set by routines
|
|
|
Category
|
Attribute
|
© 2001-2025 Fair Isaac Corporation. All rights reserved. This documentation is the property of Fair Isaac Corporation (“FICO”). Receipt or possession of this documentation does not convey rights to disclose, reproduce, make derivative works, use, or allow others to use it except solely for internal evaluation purposes to determine whether to purchase a license to the software described in this documentation, or as otherwise set forth in a written software license agreement between you and FICO (or a FICO affiliate). Use of this documentation and the software described in it must conform strictly to the foregoing permitted uses, and no other use is permitted.