MAXCHECKSONMAXTIME
|
Description
|
This control is intended for use where optimization runs that are terminated using the
TIMELIMIT (or the deprecated
MAXTIME) control are required to be reproduced exactly. This control is necessary because of the inherent difficulty in terminating algorithmic software in a consistent way using temporal criteria. The control value relates to the number of times the optimizer checks the
TIMELIMIT criterion up to and including the check when the termination was activated. To use the control the user first must obtain the value of the
CHECKSONMAXTIME attribute after the run returns. This attribute value is the number of times the optimizer checked the
TIMELIMIT criterion during the last call to the optimization routine
XPRSmipoptimize. Note that this attribute value will be negative if the optimizer terminated on the
TIMELIMIT criterion. To ensure that a reproduction of a run terminates in the same way the user should first ensure that
TIMELIMIT is set to its default value or to a large value so the run does not terminate again on
TIMELIMIT and then simply set the control
MAXCHECKSONMAXTIME to the absolute value of the
CHECKSONMAXTIME value.
|
||||
|
Type
|
Integer
|
||||
|
Topic area
|
|||||
|
Values
|
|
||||
|
Default value
|
0
|
||||
|
Affects routines
|
|||||
|
Category
|
Control
|
© 2001-2025 Fair Isaac Corporation. All rights reserved. This documentation is the property of Fair Isaac Corporation (“FICO”). Receipt or possession of this documentation does not convey rights to disclose, reproduce, make derivative works, use, or allow others to use it except solely for internal evaluation purposes to determine whether to purchase a license to the software described in this documentation, or as otherwise set forth in a written software license agreement between you and FICO (or a FICO affiliate). Use of this documentation and the software described in it must conform strictly to the foregoing permitted uses, and no other use is permitted.